Special Design Solid Carbide End Mill 6x50mm-4F Brazed For Stainless Steel
| |
| ENDMILL GRADE | | | | | | |
| HRC45 coating | | | | | | |
| HRC55 coating | | | | | | |
| HRC60 coating | | | | | | |
| HRC65 coating | | | | | | |
| Stainless Steel coating | | | | | | |
Carbide Material Introduction |
| ENDMILL GRADE | | | | |
| HRC45 carbide material | | | YL10.2 is tungsten carbide powder with 89.7% WC and 10% cobalt powder, and has high toughness and wear resistance. | Suitable for General Steel |
| HRC55 carbide material | | | K30 is ultra fine grain and containes Ni and Cr element, which provides high strength and good toughness. | General Steel, Stainless Steel, cast iron |
| HRC60 carbide material | | | WF25 is 0.4micron ultrafine carbide powder and provides very high toughness and wear resistance. | High Hard Material, steel, cast iron, etc |
| HRC65 carbide material | | | GU25UF is 0.4micron powder with 12% cobalt and has very high toughness and wear resistance.It is the most suitable for hard
cutting. | Titanium Alloy, High-temperature Alloy, Harden material, etc |
| Stainless Steel material | | | WF25 is 0.4micron ultrafine carbide powder and provides very high toughness and wear resistance. | |
